Case for Raspberry PI

Tonight’s job was dedicated to a custom case for Raspberry PI. The main goal of this case is for my own favourite project: NetPi Scanner.
This case can be usefull for many other projects that I can make or even YOU. It uses 1 push button and 2 leds. By buying this case, you are ready to make something usefull with GPIO interface and 2 leds for playing. You don’t need to weld any wires or cut your fingers. Is plug’n’play.


In this box, PIN 7 and 14 are used for leds, PIN 22 is for the push button. So, with a little Python or Bash, you can easily build some responsiveness to your Pi – You can trigger anything with the button and make an action, send an email, reboot the Pi, enable or disable services, restart some script…. your imagination will rules. You even have 1 green led and a red one for visual alerts, services status, new emails, temperature alerts….. once again, just imagine.



The web interface for configuration is also with a new look, and getting better and better. This web interface is for NetPi Scanner, but you can easily change IP address, NetMask and Gateway and even reboot the Pi.



More info at:



2 thoughts on “Case for Raspberry PI

  1. family3Tsilivi

    You made some decent points there. I checked on the net for more info about the issue and
    found most people will go along with your views on this website.

  2. Semigrey

    I’ve been browsing online more than 3 hours today, yet I never found
    any interesting article like yours. It is pretty worth enough
    for me. Personally, if all webmasters and bloggers made good content
    as you did, the net will be much more useful than ever before.


Leave a Reply

Your email address will not be published. Required fields are marked *